ICN Hard Drive Replacement

Prerequisites

Table 1. Personnel requirements
Required persons	Preliminary requirements	Procedure	Finalization
1	10 minutes	30 minutes	30 minutes

Table 2. Replacement parts
Item	Quantity	Effectivity	Part number	Manufacturer
ICN Hard Drive	1 or as required	-	See FRU manual (varies by ICN model number). Be sure to order the correct hard drive for the ICN model.	-

Table 3. Safety

Warning

Electrocution Hazard!

Dangerous voltages are present throughout the Cabinet when Power is applied.

Overview

This procedure applies to ICNs for either HDxt or DV systems:

Notice

Do not cycle ICN power using the power button on the front of the ICN. This could corrupt the ICN hard drive.
Turn off the ICNs from the Common Service Desktop (see ICN On/Off Procedure).
On the front of the ICN, press the large square button on the hard drive to be removed and then slide the hard drive out.
Perform a disk wipe on the old hard drive. See the latest revision of the Disk Management Tool Service Manual, PN 5500610-1EN available from the online documentation library.
Insert the new hard drive into the slot until secured in place.

Turn ICNs on per ICN On/Off Procedure.
Note:
For the first three or four minutes, the LEDs illuminate only at the rear of the ICN, next to the power cables. After three to four minutes, the ICN fans are audible and the LED on the front of the ICN starts flashing.
Configure the new ICN, using VRE Reconfiguration.
Perform a check scan to ensure the system is working properly.