• Object ID: 00000018WIA30984450GYZ
  • Topic ID: id_2022062 Version: 1.2
  • Date: Feb 6, 2020 1:23:27 PM

Installing table undock mechanism components

Installs the undock link and lever to the table base.

Prerequisites

Personnel requirements
Required personsPreliminary requirementsProcedureFinalization
1-10 minutes-
Tools and test equipment
ItemQuantityPart numberManufacturer
Nonmagnetic Titanium Service Tool Kit, Small Set15113258-
Consumables
ItemQuantityPart numberManufacturer
3.6 inch Cable Tie146-208758P1-

Procedure

  1. Slide the link bar through the slot in the lever.
    Figure 1. Lever Assembly
  2. Install the undock hook block onto the link bar.
    Figure 2. Undock hook block screws
  3. Install the two screws securing the block to the link bar.
  4. Slide the link bar and lever onto the pin.
  5. Install the spring to the lever using a cable tie through the slot in the lever.
  6. Install the handle end of the link bar onto the pin of the undock pedal.
    Figure 3. Location of E-clip and Link Bar
  7. Install the e-clip securing the link bar to the pedal pin.
  8. Install the bushing onto the pin.
  9. Install the reel with spring attached onto the pin.
  10. Install the plastic link lever onto the pin and the guide.
  11. Install the e-clip securing the lever to the pin.
  12. Raise the table slightly to take the weight off of the table lock safety bar and raise the safety bar.
  13. Install both the left and right lower base side covers by installing the two screws holding each to the table assembly. Attach the Velcro® securing them to the Bellows.
    Figure 4. Table covers

Finalization

  1. Do Cradle Home Table Down Interlock Adjustment.
  2. Dock the table to the scanner, and verify proper operation of the undock pedal.
  3. Dock the table and verify proper operation from the operator console.