Adjustments/Calibrations
- System
- Gradient
- Radio Frequency (RF)
- Magnet Enclosure
- Patient Table
- Global Operator Console (GOC)
  - Setting up and calibrating the Global Operator Cabinet (GOC) monitor
    Set up and calibrate the monitor for your system.
    - Electrical Safety
      You must follow all recommended safety procedures when servicing and working near energy sources.
    - Shutting down the host computer
      Shutting down the host computer shuts down the system safely and turns off the power to the host computer.
    - Setting up and calibrating the Global Operator Cabinet (GOC) monitor
      Set up and calibrate the monitor for your system.
    - Starting up the host computer
      How to start the host computer.
    - Doing a check scan
      A check scan is done at the conclusion of many procedures. This functional check assures the unit is in good clinical working order.
  - Calibrating the Eizo EV2430 24-inch monitor
- Spectroscopy

SIGNA™ Hero 3.0T Service Methods
5852800-8EN Revision 1.0
Object ID: 00000018WIA302B9880GYZ
Topic ID: id_2034916 Version: 1.2
Date: Feb 8, 2022 10:00:10 PM

Setting up and calibrating the Global Operator Cabinet (GOC) monitor

Prerequisites


Safety
Before working in any GE Healthcare MR suite or performing any GE Healthcare service procedure, you must: Have read and understood all hazard conditions and safety requirements in the latest revision of the GE Healthcare MR Service Safety Manual (5452735). Have successfully completed all relevant GE Healthcare Environmental Health and Safety (EHS) courses (or for non-GE employees, equivalent workplace training courses). Comply with all site-specific training and workplace safety requirements. If you have any safety concerns at any time, do not begin work or immediately stop work and move to a safe location. Immediately contact your supervisor or site safety officer for instructions on how to proceed.