• Discovery MR750 3.0T System Service Methods
  • 5690009-2EN Revision 4
  • Object ID: 00000018WHA302A72GYZ
  • Topic ID: id_2001664 Version: 7.4
  • Date: Nov 30, 2021 5:28:00 PM

Doing a TPS reset

This document provides instructions for doing a TPS reset and examples of the results output.

Prerequisites

Personnel Requirements
Required personsPreliminary requirementsProcedureFinalization
1-15 minutes10 minutes
Safety

Before working in any GE Healthcare MR suite or performing any GE Healthcare service procedure, you must:

  • Have read and understood all hazard conditions and safety requirements in the latest revision of the GE Healthcare MR Service Safety Manual (5452735).
  • Have successfully completed all relevant GE Healthcare Environmental Health and Safety (EHS) courses (or for non-GE employees, equivalent workplace training courses).
  • Comply with all site-specific training and workplace safety requirements.

If you have any safety concerns at any time, do not begin work or immediately stop work and move to a safe location. Immediately contact your supervisor or site safety officer for instructions on how to proceed.

Procedure

  1. To do a TPS reset, open the Common Services Desktop.
  2. Under the Utilities tab, click TPS Reset in the left navigation pane.
    Figure 1. Utilities tab
  3. Click Reset to begin the reset. The following sequence of messages shows:
    • Reset/Download TPS was successful.
    • Reset/Download TPS in progress.
    • TPS reset has completed.