• SIGNA MR355 / SIGNA MR360
  • Service Manual
  • 5856356-3EN Revision 5.0
  • Basic Service Documentation. Copyright General Electric Company.
  • Object ID: 00000018WIA30C92F20GYZ
  • Topic ID: id_13107045 Version: 3.0
  • Date: Aug 29, 2019 1:55:08 AM

CRADLE GUIDE RAIL LATCH ADJUSTMENT

Prerequisites

Table 1. Personnel requirements
Required personsPreliminary requirementsProcedureFinalization
10 minutes60 minutes0 minutes
Table 2. Tools and test equipment
ItemQuantityEffectivityPart numberManufacturer
Standard Tool (Non Magnetic)1---
Table 3. Safety

About this task

The cradle is locked in home position on the Fixed Table by a latch in the cradle, which engages a notch in the cradle guide strip near the end of the Fixed table. The cradle should be able to just engage this notch, without extra force, when pushed to home position on the table top, yet it must engage it tight enough so the table top (cradle) will not move on the Patient table freely when it is not engaged with LPCA.

Cradle Guide Rail Latch Adjustment when Table is docked to Gantry

Procedure

  1. Press Table up pedal on the Dock FRP cover, take the table to the top most condition. Press the Cradle in button on the Magnet Cover, Move the cradle inside the Bore by 400mm approximately.
  2. Loosen five screw securing guide rail.
    1. Move Guide rail up or down as required to create clearance for cradle movement.
    2. Move Guide rail forward or back word as required for cradle locking.
    Figure 1. Adjustment of Delrin Guide
  3. Press the Cradle out button on the Gantry, bring back the cradle to home position.
  4. Ensure that the cradle latches to the delrin guide and also check for the Cradle Play, by moving the Cradle. If adjustment is not good, readjust the guide following the same steps.
    Figure 2. Checking Cradle latch adjustment

Cradle Guide Rail Latch Adjustment when Table is not docked to Gantry

Procedure

  1. Slide out the cradle by 400mm approximately.
  2. Loosen five screw securing guide rail.
    1. Move Guide rail up or down as required to create clearance for cradle movement.
    2. Move Guide rail forward or back word as required for cradle locking.
    Figure 3. Adjustment of Delrin Guide
  3. Take back the cradle to home position. Ensure that the cradle latches to the delrin guide and also check for the Cradle Play, by moving the Cradle. If adjustment is not good, readjust the guide following the same steps.
    Figure 4. Checking Cradle latch adjustment

Finalization

Finalization

No finalization steps.