• SIGNA MR355 / SIGNA MR360
  • Service Manual
  • 5856356-3EN Revision 5.0
  • Basic Service Documentation. Copyright General Electric Company.
  • Object ID: 00000018WIA30AFBF20GYZ
  • Topic ID: id_13106684 Version: 1.2
  • Date: Jul 6, 2019 12:03:29 AM

OSHA Lockout Tagout Requirements

The following are the contents of the lock out/tag out kit:

  • Personal Lock: 46-194427P320

  • Transition Lock: 2387081

  • LOTO Tag: 46-194427P322

  • Transition Tag: 2393064

  • Multi Locking Device: 46-194427P313

  • Line cord plug cover: 46-194427P231

Scope

This standard covers the servicing and maintenance of machines and equipment in which the unexpected energization, or start-up, of the machine or equipment could cause injury to employee.

Application

This standard applies to the control of energy during servicing and/or maintenance of machines or equipment.

Exceptions

Minor adjustments and other minor service activities, which take place during normal operation, are not covered by this standard if they are routine, repetitive, and integral to the use of the equipment for operation, provided the work is performed using alternative measures that provide effective protection.

This standard does not apply to work on cord and plug-connected electric equipment. Exposure to the hazards of unexpected energization, or start-up, of such equipment is controlled by the unplugging of the equipment from the energy source, and by the plug being under the exclusive control of the employee performing the servicing or maintenance.

Purpose

Require employers to establish a program, and use procedures for affixing appropriate lockout devices, or tagout devices, to energy-isolating devices, and to otherwise disable machines or equipment to prevent unexpected energization, start-up, or release of stored energy in order to prevent injury to an employee.

General Application

If an energy-isolating device is not capable of being locked out, use a tagout device. Such device shall be attached at the same location that the lockout device would have been attached.

Definitions

Energy-isolating device:

Mechanical device that physically prevents the transmission or release of energy (i.e., manually operated electrical circuit breaker or disconnect switch).

Energy source:

Any source of electrical, mechanical, hydraulic, pneumatic, chemical, thermal, or other energy.

Lockout:

: Placement of a lockout device on an energy-isolating device, in accordance with an established procedure, ensuring that the energy-isolating device and the equipment being controlled cannot be operated until the lockout device is removed. It is also necessary to attach a tagout device to the lockout device.

Lockout device:

A device that uses a positive means such as a lock (either a single key or combination type) to hold an energy-isolating device in the safe position.

Note:

Any lock that uses a key to lockout a device must have only ONE key assigned to the lock owner.

Tagout:

Placement of a tagout device on an energy-isolating device, in accordance with an established procedure, to indicate that the energy-isolating device and the equipment being controlled may not be operated until the tagout device is removed.

Tagout device:

A prominent warning device, such as a tag and a means of attachment, that can be securely fastened to an energy-isolating device in accordance with an established procedure, to indicate that the energy- isolating device, and the equipment being controlled, may not be operated until the tagout device is removed.

Lockout / tagout:

If an energy-isolating device is not capable of being locked out, the site energy control program shall use a tagout system.

Application of Control

The established procedure for the application of energy control shall cover the following:

  • Preparation for shutdown.

  • Machine or equipment shutdown.

  • Machine or equipment isolation

  • Lockout or tagout devise application

  • Verification of isolation

Basic rule: All equipment shall be locked out or tagged to protect against accidental or inadvertent operation when such operation could cause injury to personnel.