Object ID: 00000018WIA30F7EE20GYZ
Topic ID: id_13106742 Version: 3.0
Date: Aug 29, 2019 1:46:29 AM

Respiratory Gating Signal Checks

Prerequisites

Table 1. Personnel requirements
Required persons	Preliminary requirements	Procedure	Finalization
1	Not Applicable	25 minutes	Not Applicable

Table 2. Tools and test equipment
Item	Quantity	Effectivity	Part number	Manufacturer
Respiratory Bellows	1	-	46 265679G1	-

Table 3. Safety

Notice

Possible equipment damage. Completely remove the Quad Head Coil from the cradle before performing any body scans. Failure to do so may damage the head coil T/R network.

Notice

Never vent the bellows. Always connect the bellows to the PAC Assembly before stretching it. Failure to connect bellows to PAC Assembly first causes inaccurate waveforms and, therefore, inaccurate results.

Procedure

Connect bellows to the Enclosure Interface module.
Go to Tools tab.
Select Gating Control menu.
Select Respiratory. The Respiratory Waveform appears
Take the respiratory bellows in both hands and gently pull on either end.
Pull the bellows by hand duplicating the motion of typical regular breathing. If the bellows and respiratory compensation software is working properly the LED's should follow the actions of the bellows. If it does not, proceed by troubleshooting the bellows (for tears or holes), connections and then the PAC assembly for problems.
Verify waveform is displayed following action of bellows.

Note:
The respiratory waveform will be displayed on the IRD if the system is so equipped. If not, it will be displayed on the Enclosure display.

Finalization

No finalization steps.