Reset Term Server

Prerequisites

Table 1 Personnel requirements
Required persons	Preliminary requirements	Procedure	Finalization
1	Not Applicable	10 minutes	Not Applicable

Table 2 Required conditions
Condition	Reference	Effectivity
This procedure is only for new software loads.	-	-

Exit Guided Install by selecting File > Quit.
Restart the system and log in.
- User ID: root
- Password: operator
  
  note:
  It is possible that the customer changed the default password. If you cannot log in, contact the customer for the correct password.
Remove the power connector from the term server.
Press and hold the small square Reset button (next to the power jack), and connect power to the term server while continuing to press this button.
Continue pressing the Reset button for 20 seconds, or until the LED flashes 1–5–1.
Verify communication between the host PC and term server as follows:
1. Open a C shell.
2. To ping the ts1 address, type ping hostname-ts1 (where hostname is the hospital name). Press Enter.
  
  Figure 1. Ping ts1 — Good Communication
  
  If an improper response of Host Unreachable appears, repeat this procedure.
  
  Figure 2. Ping ts1 — Communication Error Message
To stop the test, press Ctrl-c.

Proceed to the appropriate MR service software loading procedure. See .