Functional Checks
- Functional Checks
- System
  - Doing a compressor pressure check
    Do a check of the cryocooler compressor supply pressure.
  - Checking the RF screen room door
    Make sure the RF screen room door is functioning correctly.
  - B0 Drift Functional Check
  - Doing a check scan
    A check scan is done at the conclusion of many procedures. This functional check assures the unit is in good clinical working order.
  - Emergency Stop (E-Stop) planned maintenance
  - Emergency Off (E-Off) planned maintenance
  - fMRI QA Tool
  - HEC Hose Inspection, Coolant Fill, and Coolant Leak Check
  - Finalizing the HEC hose inspection, coolant fill, and coolant leak check
  - Identifying the Image Compute Node (ICN)
  - MDP power and ground and battery replacement label check
    MDP power and ground connections must be tight in order to avoid system failures.
  - Magnet Rundown Unit (MRU) Functional Check
  - Doing an MRU yearly service check (MRU, ERU, or EDU PM testing matrix)
    The model number is listed on the side of the MRU, ERU, or EDU. Refer to the appropriate vendor manual available from the online documentation library for applicable testing procedures.
  - Peripheral Pulse Probe Check
  - Spike Noise Check
  - System Level Correlated Noise Check
  - Checking the oxygen monitor
    References to various Oxygen Monitor Subsystem Manuals.
  - Checking and adjusting the patient intercom functionality
    GOC Audio Assembly (GOCAA) controls are adjusted at factory for best sound quality. This document describes how to check and confirm volume and quality of sound heard from speaker in the magnet bore and from speaker at the Scan Control and Intercom Module (SCIM). Directions for sound adjustments are also provided if needed.
  - Checking the gradient and system PDU power and ground connection
    PDU power and ground connections need to be tight in order to avoid system failures.
- Radio Frequency (RF)
- Coils
- Magnet Enclosure
- Patient Table
- Patient/PAC
- Grounding and Leakage Current

Optima MR450w BASE 1.5T System Service Methods
5690012-2EN Revision 3
Object ID: 00000018WIA30F8B950GYZ
Topic ID: id_2026064 Version: 1.2
Date: May 5, 2020 3:58:51 PM

Finalizing the HEC hose inspection, coolant fill, and coolant leak check

Procedure

When finished filling the tanks with coolant, place the funnel and tank funnel extension at the bottom of the HEC.
Keep any unused coolant for future use.
After the procedure is completed, view the hose connections closely to check for any leaks.
Check the hoses a second time after a few days (during installation) for any possible leaks.