Prerequisites
Table 1. Personnel requirements| Required persons | Preliminary requirements | Procedure | Finalization |
|---|
| 1 | Not Applicable | 30 minutes | Not Applicable |
Table 2. Tools and test equipment| Item | Quantity | Effectivity | Part number | Manufacturer |
|---|
| MR Applications
Software DVD | 1 | - | - | - |
About this task
Overview
IMPORTANT: Make sure that the latest Service Pack is loaded.
See the latest revision of MR Service Pack Software Matrix, DOC1667089, available from the online documentation library.
If more information is needed for how to load Service Packs, see Installing Service Packs.
Procedure
- After the system reboots, the Welcome to MRHost screen displays. Log in using these parameters:
-
User ID: root
-
Password: operator
- Insert the MR Applications Software DVD into the appropriate
DVD drive when prompted. Click OK after the
DVD drive LED stops blinking.
Note:
Dell T5810 host PCs have two solid-state disks. Raid will
not be created for the /export/home1 partition.
One disk will be used for the OS while the other will be used for
the /export/home1 partition.
- From the Select your locale window, select
the correct language for the site. Click OK.
A series of messages and a progress bar report the progress
of the installation. When complete, the Guided Install screen appears.
- The prompt Do you want to load GI Configuration from
DVD? appears.
-
(For existing systems or training
PC re-installation) Insert the Save Info media and select Yes after the DVD drive LED stops blinking. Load GI restores Guided Install information. When the
process is complete, reinsert the MR applications software DVD and
continue to HIPAA/Security (for DV25.1 and later)
or Verification (for DV25.0).
-
(For new systems) Close the drive and select No. Use the information recorded in Guided Install Site Configuration Options to complete this section.
-
(For first-time training PC installation) Close the drive and select No. Use the information recorded in Guided Install Site Configuration Options to complete this section.
-
(For DV25.1 and later) Select security level.
- Go to Preferences > HIPAA/Security.
- Select the security option appropriate for the site per the
customer. Refer to Security Levels for
more information.
Note:
(For DV26.0 and later) You cannot choose Signa Secure Advanced at this point. If the customer
has purchased the Signa Advanced key, complete the remaining software
installation in typical security mode, then download the options and
configure to the Signa Secure Advanced.
- Proceed to the Verification tab. Review
the entries on the page to determine if all entries passed verification
(the Install Software button will not be active
if there are any failures). Failed entries result from missing or
improperly formatted entries.
- Go to the tab with the error and correct it. Click Install to open the Verification tab again.
- If all entries pass verification, click Install Software to begin the MR applications load. This process takes 15-20 minutes.
Note:
A prompt appears reminding you to configure the NTP server
(if present) through the Network Info tab. It
also reminds you to verify that the current time and time zone are
configured properly on the Set Time/Date tab.
If both are correct, select Confirm.
If not, select Abort and configure the NTP
server (if present) and the current time and time zone.
- A confirmation message appears after the applications load completes. Click OK to close the window. Return to Loading Host System Software (Quick Start) to continue installation.
Finalization
IMPORTANT: Make sure that the latest Service Pack is loaded. See the latest revision of MR Service Pack Software Matrix, DOC1667089, available from the online documentation library. If more information is needed for how to load Service Packs, see Installing Service Packs.
