• Topic ID: id_11038731
  • Version: 2.0
  • Date: Jan 30, 2019 9:42:53 PM

LCD Monitor Replacement for Z820 PC

Prerequisites

This procedure describes and illustrates the steps necessary to replace either LCD Display Monitors located with the Operator Console.

Figure 1. EIZO LCD Video Monitor

1 Power-Off (Shut Down) the Console

Procedure

  1. Select one of the following methods to power off the Operator Console:

    • If applications are running, click the Shut Down icon and select Shut Down.

    • If applications are down, open a Unix Shell using the Toolchest. Type: {ctuser@hostname} halt and press Enter.

    The Operator Console monitor will display a ‘System Halted’ message when it is acceptable to power off the Operator Console.

  2. Power OFF the Operator Console.

2 Remove Old LCD Monitor

Procedure

  1. Disconnect the Power Cord and Video Cable from the LCD Monitor being replaced.
  2. Remove the LCD Monitor and set aside.

3 Install Replacement LCD Monitor

Procedure

  1. Place the replacement LCD monitor on the Operator Console.
  2. Connect video cable and power cable to the LCD monitor.

    Figure 2. Video Cable and Power Cable Connection

    Scan Monitor

    • Video cable from Console Host DP1 to monitor DVI

    • Power cable from Console AC Box J10

    • Route through the cable keeper

    Image Monitor

    • Video cable from Console Host DP0 to Monitor DVI

    • Power cable from Console AC Box J9

    • Route through the cable keeper

4 Verify LCD Monitor Replacement

Procedure

  1. Power ON the Operator Console at the console front panel switch.
  2. Visually verify that the LCD Monitor powers up and receives a video signal.
    note:

    The LCD Monitor Power LED will illuminate Green if both power and video are present. If the video signal is missing, the LCD Monitor Power LED will illuminate Yellow.

  3. In order to assure proper operation of the LCD Monitor it is necessary to perform LCD Video Monitor Setup.

    Return to this procedure when finished.

5 Finalization

After completing the LCD Monitor Setup Procedure, perform a complete shutdown of the Operator Console and restart the system.