SIGNA™ Hero 3.0T Service Methods
5852800-8EN Revision 1.0
Object ID: 00000018WHA300E62GYZ
Topic ID: id_2001470 Version: 3.0
Date: Jul 8, 2019 1:44:56 PM

Shutting down the ICN

Prerequisites


Personnel requirements
Required Persons	Preliminary requirements	Procedure	Finalization
1	-	25 minutes	-


Safety
Before working in any GE Healthcare MR suite or performing any GE Healthcare service procedure, you must: Have read and understood all hazard conditions and safety requirements in the latest revision of the GE Healthcare MR Service Safety Manual (5452735). Have successfully completed all relevant GE Healthcare Environmental Health and Safety (EHS) courses (or for non-GE employees, equivalent workplace training courses). Comply with all site-specific training and workplace safety requirements. If you have any safety concerns at any time, do not begin work or immediately stop work and move to a safe location. Immediately contact your supervisor or site safety officer for instructions on how to proceed.

Notice

Premature ICN failure

Follow this procedure for removing power to the ICN chassis. Failure to properly power down ICNs may result in premature ICN failure.

Do not turn power off to the ICNs using the power button on the front panel. The ICNs have software running on disk drives that may become corrupted if not powered down properly.

About this task

The ICN is powered down when the host software is shut down. To shut the ICN down individually, use the VRE Power Control utility. If the preferred shutdown method does not work, a last resort is to use the ICN power button.

Please choose from the following: