• SIGNA™ Hero 3.0T Service Methods
  • 5852800-8EN Revision 1.0
  • Object ID: 00000018WIA302E1110GYZ
  • Topic ID: id_2003422 Version: 2.2
  • Date: Oct 16, 2019 12:14:37 PM

Removing the magnet service access vent

Removes the service access vent from the magnet enclosure allowing a ladder to stand close to the magnet on the left-hand side.

Prerequisites

Personnel requirements
Required personsPreliminary requirementsProcedureFinalization
1-20 minutes-
Tools and test equipment
ItemQuantityPart numberManufacturer
Nonmagnetic Titanium Service Tool Kit, Small Set15113258-
Safety

Before working in any GE Healthcare MR suite or performing any GE Healthcare service procedure, you must:

  • Have read and understood all hazard conditions and safety requirements in the latest revision of the GE Healthcare MR Service Safety Manual (5452735).
  • Have successfully completed all relevant GE Healthcare Environmental Health and Safety (EHS) courses (or for non-GE employees, equivalent workplace training courses).
  • Comply with all site-specific training and workplace safety requirements.

If you have any safety concerns at any time, do not begin work or immediately stop work and move to a safe location. Immediately contact your supervisor or site safety officer for instructions on how to proceed.

About this task

Do the following tasks to complete removing the magnet service access vent:
  • Removing the magnet service access trim
  • Removing the magnet front service access panel
  • Removing the magnet rear service access panel
  • Removing the magnet service access vent