• SIGNA™ Hero 3.0T Service Methods
  • 5852800-8EN Revision 1.0
  • Object ID: 00000018WIA3096D010GYZ
  • Topic ID: id_2002973 Version: 5.5
  • Date: Jan 19, 2022 3:46:26 AM

Installing the magnet rear trim ring

Installs the rear trim ring onto the rear endbell.

Prerequisites

Personnel requirements
Required personsPreliminary requirementsProcedureFinalization
1-5 minutes-
Required conditions
Left-hand rear cover is installed.
Right-hand rear cover is installed.
Rear cable cover is installed.
Rear endbell is installed.
Safety

Before working in any GE Healthcare MR suite or performing any GE Healthcare service procedure, you must:

  • Have read and understood all hazard conditions and safety requirements in the latest revision of the GE Healthcare MR Service Safety Manual (5452735).
  • Have successfully completed all relevant GE Healthcare Environmental Health and Safety (EHS) courses (or for non-GE employees, equivalent workplace training courses).
  • Comply with all site-specific training and workplace safety requirements.

If you have any safety concerns at any time, do not begin work or immediately stop work and move to a safe location. Immediately contact your supervisor or site safety officer for instructions on how to proceed.

Procedure

  1. Align five ball and catch strikers on the back of the rear trim ring with the five ball and catch latches on the rear endbell.
    Figure 1. Rear trim ring alignment
    1Rear endbell ball catch latches
    2Rear trim ring ball catch strikers
  2. Install the rear trim ring onto the magnet enclosure. Make sure the five ball and catch latches retain the trim ring.