• SIGNA™ Hero 3.0T Service Methods
  • 5852800-8EN Revision 1.0
  • Object ID: 00000018WIA305D7650GYZ
  • Topic ID: id_2024723 Version: 1.28
  • Date: Jul 14, 2021 11:00:03 PM

Configuring DICOM image transfers to a network node

Configure DICOM image transfers to a network node and check for successful DICOM network node configuration.

Prerequisites

Personnel requirements
Required personsPreliminary requirementsProcedureFinalization
1-10 minutes-

About this task

Important: When secure DICOM push is configured in one-way TLS/SSL authentication, DICOM ping will only succeed from MR to the networked node and will fail from the networked node to MR. This is expected because the networked node does not have a trusted certificate from the MR scanner. DICOM ping will succeed both ways in secure mode only when two-way TLS/SSL authentication is configured.

Procedure

  1. In the Configure Network Hosts window, click Add.
    Figure 1. Add a remote host
  2. Configure the network node by choosing one of the following:
    OptionDescription
    DICOM over TCP/IP (Legacy method unsecure)Enter the host name, display name, IP address, port, and AE title information of the server. The default port for other GE devices is 4006.
    DICOM over TLS (secure, available with SW version PX29.0 and later only)Proceed only if certificates have been installed and set up per workflow MR Scanner set up as secure client in Importing and exporting TLS certificates.
    1. Enter the host name, display name, IP address, port, and AE title information of the server. The default port for other GE devices is 2762.
    2. Check the lock icon.
  3. Click Save.
  4. Click OK.