SIGNA™ Hero 3.0T Service Methods
5852800-8EN Revision 1.0
Object ID: 00000018WIA30700E20GYZ
Topic ID: id_13106549 Version: 7.5
Date: Nov 1, 2021 10:59:19 AM

Magnet FRU

Magnet FRU List

Table 1. Resonance Module, etc
Item Number	Part Number	Description
1	5384700-2	Dual Drive Transmit Receive Switch
2	5398314	Preamp Combiner
3	5620700	Collector, Kizuna 3T Busbar Y Assembly Replacement
4	5620701	Collector, Kizuna 3T Busbar XZ Assembly Replacement
5	5503386	`(For PX25.0, PX26.1, and higher)` Gen1 DPP RRx Pport 3T HLA
5	5641325* 5789759	`(For PX26.1 and higher)` Digitized Per Pin Receiver FRU Gen2 Direct Sampled (DS) Remote Receiver (RRx) P-port 3T High Level Assembly (HLA) (requires DV28/RX28/PX28 software)
6	5434906* 5434906-2	Rx Distribution FRU DS Rx Distribution HLA (requires DV28/RX28/PX28 software)
7	5160929-52	SRI4 with Remote Intercom Board 3 Note: Must be used with compatible SW loads PX25.0.
7	5160929-54	Scan Room Interface FRU Note: Compatible with SW loads PX25.1 and later.
8	5341318-6	PAC-5 Assembly for Kizuna Note: Must be used with compatible SW loads PX25.0.
	5341318-9	Fixed Table Physiological Acquisition Controller FRU Note: Compatible with SW loads PX25.1 and later.
	9	5502141-2	Operator Control Panel - Left
10	5502141	Operator Control Panel - Right
11	5502140-2	In-Room Display
12	2208999-26 (New design) or 2208999-23 (Previous design)	Kizuna 3.0T RF Body Coil FRU Note: Compatibility with hardware (body coil mount) exists. For 2208999-26 body coil, always replace with 2208999-26. Part number can be identified by Hart ID through host computer. For 2208999-23 body coil, please order 2208999-23 until FRU stock becomes zero even though 2208999-26 can be used for previous body coil mount.
13	5746039 (New design) or 5589364 (Previous design)	Kizuna 3.0T Body Coil Mount - Front Note: Compatibility with the other hardware exists. Always replace the same part. For 5746039, it can be identified by the label on front mount base written as 5720297. For 5589364, it can be identified by the label on front mount base written as 5599908.
14	5746040 (New design) or 5589366 (Previous design)	Kizuna 3.0T Body Coil Mount - Rear Note: Compatibility with the other hardware exists. Always replace the same part. For 5746040, it can be identified by the label on rear mount base written as 5719957. For 5589366, it can be identified by the label on rear mount base written as 5599909.
15	5534741	VRMw FRU Gradient Coil Assembly
16	5628312	VRMw Gradient Coil Mounting Kit, FRU
17	5604785	Airflow Sensor Assembly Kizuna
18	5561809	Bore Light Assembly A
19	5561810	Bore Light Assembly B
20	5555419	Laser and Bracket Assembly
21	5180907-52	Run M3350 MAG-SRI-J10 to MAG-BORE, Bore Temperature, RoHS
22	5542955	VRMW Coolant Manifold FRU
23	5482545	Body Coil Gap Foam 6,5 X 6,5 X 2280 with Adhesive
24	5769494	IRD Bracket Collector
	5473879	Shim Tray Assembly, Molded, Extractor Knob, VRMW
	5428096	3.0T DVw Field Passive Shim Kit
	5542958	VRMW Shim Tray Locking, FRU
	5507276	Gas Line Adaptor, Supply, Long 180
	5507281	Gas Line Adaptor, Return, Long 180
	5627815	Kizuna 3T Terminal Cover Kit
	5758591	Twinax 100 Ohm Terminator
* When stock of 5641325 or 5434906 run out, the Field Engineer will have to replace them with 5789759 (quantity 4), 5434906-2 (quantity 1), and 5758591 (quantity 1). These new parts require that the system is running software DV28 or later.

Table 2. Magnet Enclosure
Item Number	Part Number	Description
1	5481562	Front Upper Cover Assembly 3T Wide Performance
2	5478984	Front Right-Hand Lower Cover Assembly 3T Wide Performance
3	5478978	Front Left-Hand Lower Cover Assembly 3T Wide Performance
4	5490411	Dock Interface Cover
5	5481566	Front Trim Lower Left-Hand Cover Assembly 3.0T Wide Performance
6	5481564	Front Trim Upper Cover Assembly 3.0T Wide Performance
7	5479004	Front Bridge Cover Molded 3T Wide Performance
8	5479007	Laser Cover Assembly 3T Wide Performance
9	5479009	Endbell Front Cover 3T Wide Performance
10	5479039	Side Cover, Right-Hand Upper Front Molded 3T Wide Performance
11	5534678	Side Cover Left-Hand Upper Front Assembly
12	5478973	Center Top Cover, Left-Hand Molded 3T Wide Performance
13	5481547	Side Cover, Right-Hand Upper Rear Molded 3T Wide Performance
14	5479031	Left-Hand Lower Side Cover Assembly 3T Wide Performance
15	5478988	Side Nameplate Cover Assembly 3T Wide Performance
16	5486329	Fill Port Cover Bonded
17	5736837 (New design) or 5555501 (Previous design)	Front Bridge Assembly Note: Compatibility with the other hardware exists. Always replace the same part. For 5736837, it can be identified by the label on front Body Coil Mount Base written as 5720297. For 5555501, it can be identified by the label on front Body Coil Mount Base written as 5599908. Note: When the FRU stock of 5555501 (previous design) becomes zero, it is necessary to replace the following parts at the same time. Front Bridge (new design) (5736837) Front Body Coil Mount (5746039) Rear Body Coil Mount (5746040) Body Coil (2208999-26) Rear Endbell (5534815) (FRU has already been reworked for new rear mount)
18	5478997	Rear Left-Hand Cover Assembly 3T Wide Performance
19	5478999	Rear Right-Hand Cover Assembly 3T Wide Performance
20	5534815	Rear Endbell Cover Assembly
21	5582665	Rear Trim Ring Collector
22	5534819	Rear Cable Cover Bonded
23	5534680	Left-Hand Side Access Cover Molded
24	5481545	Side Cover, Left-Hand Upper Rear Molded 3T Wide Performance
25	5555505	Rear Bridge Assembly
26	5610745	Rear Bridge Left-Hand Cover Assembly
27	5538897	Rear Bridge Right-Hand Cover Molded
28	5538901	Rear Bridge Center Cover Molded
29	5538903	Rear Bridge Bottom Cover Molded
30	5540714	Illuminated GE Logo
31	5816129	Accent Lighting Conversion Kit
31	5816130	Accent Lighting Repair Kit
32	5180380	Wheel Housing Assembly
33	5366374-2	Ambient Temperature Sensor
34	46-221773P2	Speaker
35	2355200-2	UTNS Antenna - RoHS
36	5437790	Snap Action Switch
37	5620247	Bridge Trim
38	5505282	Side Cover Dolly
39	5154717	Cap for Front Bridge
40	5573178	Cap for Rear Bridge
	5174012	Touchup Paint, GEHC N9, 46-221381P11