• Topic ID: id_11039096
  • Version: 5.0
  • Date: Jan 27, 2022 12:51:02 AM

Cradle Replacement

Prerequisites

Procedure

    Notice Image
    • notice
    • Understand and follow the Safety Guidelines Manual.
  1. Move the cradle OUT to its fully retracted position (farthest from Gantry).
  2. Raise the Table to its highest position.
  3. Remove power from Table by turning off “120VAC”, “Axial Drive” and “HVDC” switches on the service switch panel.
  4. Remove the six Allen screws from the cradle end, and then slide out the cradle.

    Figure 1. Cradle Replacement

    Notice Image
    • caution
    • Potential for injury to service persons!
    • Understand and follow the Safety Guidelines. The injury risk from removing and installing the heavy table cradle MUST be minimized by two engineers to safely complete these tasks.
  5. Install the new cradle.

Finalization

  1. After installing the new cradle, perform the following adjustment according to Align, Setup, Cals -> Table.

    • GAP BETWEEN CRADLE AND CRADLE SUPPORT