• Topic ID: id_16157866
  • Version: 4.0
  • Date: Jan 20, 2020 8:36:04 PM

GTCN Replacement (GT1700V)

Prerequisites

Overview

This procedure is for the GT1700V.

Procedure

  1. Raise the Table to maximum height.
  2. Move the Cradle to OUT limit position.
  3. Remove power from Table by turning off 120VAC, Axial Drive and HVDC switches on Service Switch Panel.
  4. Remove the left top cover.
  5. Cut any tie-wraps, and disconnect all cable connector from the GTCN Assy.
  6. Unscrew 7 screws, and remove the GTCN Assy.
  7. Install the new GTCN Assy into place, and tighten the 7 screws. One of the screws is used for Table type identification. Select the appropriate screw position depending on your Table type.

    Figure 1. GTCN Assy

  8. Re-connect all wires and cable connectors, and fix the cables using tie-wraps.

Finalization

  1. Re-install the Table covers.
  2. Power up the Table from the Service Switch Panel.
  3. Verify that the Cradle function is operating normally.