• Topic ID: id_15460404
  • Version: 4.0
  • Date: Jan 20, 2020 8:32:24 PM

Inverter Assy Replacement

Prerequisites

Overview

Procedure

  1. Raise the Table to maximum height.
  2. Move the Cradle and IMS to OUT limit position.
  3. Remove power from Table by turning off 120VAC, Axial Drive and HVDC switches on Service Switch Panel.
  4. Remove the Front Base Cover.
  5. Cut any tie-wraps, and disconnect motor wires (U, V, W) from the front of the Inverter Assy.
  6. Disconnect the following cable connectors:

    • Power Cable Connector

    • J1 - on the GTCB Assy

    • J2 - on the GTCB Assy

    • J100 - behind the Inverter Assy

    • J101 - behind the Inverter Assy

    • J102 - behind the Inverter Assy

  7. Loosen a screw, and slide the Inverter Assy toward the Gantry, then remove it from the Table.

    Figure 1. Inverter Assy Removal

  8. Install the new Inverter Assy in place, and tighten the screw.
  9. Re-connect all wires and cable connectors, and fix the cables using tie-wraps.

Finalization

  1. Re-install the Table covers.
  2. Power up the Table from the Service Switch Panel.
  3. Verify that the Table Up/Down function is operating normally.