Rotor Diagnostic Test

The purpose of this test is to drive the rotation inverter in high speed and low speed modes on the tube in order to identify a defective rotation board or a wrong connection between rotation board and tube.

1. If desired, you may check any or all of the following:
   1. PPC kV control board alive and running: DS17-DS24 LEDs are lit successively or a combination of them blink
   2. Cabling between rotation board and tube checked
   3. Rotation board alive and running: DS5 LED blinking for rotation V2 (or DS4 LED blinking for rotation V3)
   4. Rotation board DC supply present: DS7 neon is lit
2. Launch the GENERATOR TOOL from the DIAGNOSTICS tab in the Common Service Desktop.
3. Launch the Rotor Diagnostic tool.
4. Run the test. A rotor sequence will proceed.
5. If a problem occurs, check the error log.