STEP 13A: Anchor the System

Potential for injury.
If there is a load on the tilt bracket, removal may cause the gantry to suddenly tilt all the way back due to a possible lack of hydraulic pressure.
If tilt bracket is not loose, stop and put the M12 bolts back in and tighten the tilt bracket back in place.

1. Assemble the anchors. Use the anchor seating tool to tap them into the holes.
2. Use a calibrated torque wrench to torque all eight anchor bolts to 75 ± 6 N-m (55 ± 5 ft-lb).
3. There should be no more than 21 mm (1 in.) showing above the nut and at least one full turn of thread is showing above the lock ring.
4. Remove the laser alignment tools and store them neatly in the shipping case.